![]() It is a time consuming process but very worth it. We ended up painting 3 coats of paint to each part of the stair – taking approximately 4 hours each with two people, plus the additional time for a light sand and tack cloth between coats. At the risers, because they will have less wear, we opted to use BEHR Premium Alkyd Satin Enamel in White, which we will also be using at all of our finishing trim throughout. Formulated for demanding marine and industrial requirements, Armorseal 1000 HS Epoxy dries rapidly to a tough, high-gloss finish with excellent resistance to alkalies, abrasion, corrosion and chemical attack. It is made for traffic surfaces and provides an extra durable finish without a protective top-coat. A two-component, high-solids, heavy-duty polyamide epoxy coating. We already did a light sand after the primer, so all we need to get painting is to tack cloth the entire stair again and make sure its very clean.įor the paint at the railing and treads we opted to use Sherwin William’s ArmorSeal Tread-Plex paint in the color Tricorn Black. Now we’re ready to paint and we’re essentially going to repeat the same process as priming. ![]() After the primer had a chance to dry we followed up with a light sanding using 220 grit sandpaper. With two people, priming our entire staircase took about 4 hours. For our stair we used the Zinsser BIN shellac-based primer because it both blocks the stain from penetrating through the paint and has great adhesion to surfaces. When painting over a stained wood it is important to use a stain blocking primer. After days of tedious prep, we were ready to finally get painting. Again, the prep stages of painting something like this are extremely important. ![]() At this point I thoroughly cleaned the entire stair with Krud Kutter, before following up with a tack cloth to remove any dust or particles. You’ll then need to sand again with about a 60 grit sandpaper to smooth out the wood filler.Īfter this you’re almost ready for primer. We then wood filled in any areas that needed touch up (our stair is 30 years old and had a lot of wear and tear) and knots in the wood. A Sherwin Williams guy sold her Armorseal Tread-plex Acrylic Water Based Coating. We started by sanding the entire stair including the railing, treads, risers, and skirts. We’ve also got an entire YouTube video that walks through the process, linked above.īecause we were working with a stained wood stair, the prep and priming stages are probably the most important. We’ll break down all of the products we used to prep, prime, and paint our stair.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |